Desoldering Wick and Flux Paste Kit, 10-Foot Copper Braid with 10cc No-Clean Rosin Flux for PCB Repair
Desoldering Wick and Flux Paste Kit, 10-Foot Copper Braid with 10cc No-Clean Rosin Flux for PCB Repair
This desoldering wick and flux paste kit pairs two everyday electronics-repair supplies for cleaner component removal and rework. The fine copper braid absorbs molten solder from PCB pads and leads, while active rosin flux improves wetting and flow so stubborn joints can be heated and cleared with less repeated contact.
The documented kit includes a 10-foot, 0.08-inch-wide wick and 10cc of R08010 no-clean flux in white or yellow variants, with larger three-plus-two configurations also listed. The flux is intended for PCB, BGA and SMD soldering and leaves minimal residue after use. Apply only a small amount, heat the joint through a fresh section of braid and lift the iron and wick together. Follow safe soldering, ventilation and surface-cleaning practices.
Specifications
- Kit: Desoldering wick and solder flux
- Wick material: Copper with flux
- Wick length: 10 feet
- Wick width: 0.08 inch
- Flux volume: 10cc
- Flux model: R08010
- Flux type: No-clean rosin
- Flux colors listed: White or yellow
- Configurations: 1+1 or 3+2
- Uses: PCB BGA and SMD rework
Frequently Asked Questions
What is included in the basic kit?
The documented configuration combines one 10-foot copper wick with 10cc of no-clean rosin flux.
Why use flux with desoldering braid?
Flux improves wetting and solder flow, helping the copper braid absorb molten solder more efficiently.
Which electronics work is it intended for?
The kit is described for PCB, BGA and SMD soldering, component removal and general electronics rework.
Does the flux require full cleanup?
It is a no-clean formulation designed to leave minimal residue, though sensitive boards should still be inspected.