Rosin Flux Desoldering Wick Kit with Three 10-Foot Pure Copper Braids in 0.08, 0.10 and 0.12-Inch Widths
Rosin Flux Desoldering Wick Kit with Three 10-Foot Pure Copper Braids in 0.08, 0.10 and 0.12-Inch Widths
Rosin flux desoldering wick pulls molten solder from PCB pads, surface-mount parts and through-hole joints with tightly woven pure copper and strong capillary action. Pre-coated braid is ready to use without adding flux, helping speed component removal while leaving a low-residue finish on delicate electronics.
The kit supplies three precision-wound ten-foot spools in 0.08, 0.10 and 0.12-inch widths, so you can use fine braid on phone or laptop boards and a wider strip on larger terminals. A plastic storage box protects the spools between repairs and helps preserve the flux coating for hobby benches, workshops and laboratory rework.
Specifications
- Product: rosin-flux desoldering wick kit
- Spools: 3
- Length per spool: 10 feet
- Widths: 0.08 0.10 and 0.12 inches
- Material: pure woven copper
- Coating: pre-applied rosin flux
- Residue: no-clean low-residue listing
- Storage: plastic packing box
- Included references: CP-2030 CP-2530 and CP-3030
- Uses: PCB rework phone repair laptop repair SMD parts through-hole joints pads and terminals
- Dimensions: 1.81 x 1.81 x 0.47 inches
- Weight: 1.21 ounces
- Brand: JoTownCand
- Model: DW-202530
Frequently Asked Questions
Is extra flux required before using this wick?
No. The copper braid is pre-coated with rosin flux and designed to work straight from the spool on compatible joints.
Which widths are included?
You receive 0.08 0.10 and 0.12-inch braids with ten feet on each spool for fine pads and larger solder joints.
Can the wick be used on small electronic boards?
Yes. The narrower sizes suit careful phone laptop and SMD rework when used with controlled heat to protect pads and traces.
How should I use a fresh section of braid?
Place clean braid over the molten joint heat it from above and trim away the solder-filled section before moving to another connection.